#######################################################################

DELL POWERCONNECT 35xx v1.0.0.24 FIRMWARE README

#######################################################################

NOTE: This ReadMe provides information for PowerConnect 35xx v1.0.0.24 firmware.


#######################################################################
CRITICALITY
#######################################################################

Recommended - Dell recommends applying this update during your next 
scheduled update cycle. The update contains feature enhancements or 
changes that will help keep your system software current and compatible 
with other system modules (firmware, BIOS, drivers and software). 


#######################################################################
DESCRIPTION
#######################################################################

* This is the firmware release v1.0.0.24 for the Dell PowerConnect 35xx
Ethernet switch.

* This firmware is transferable to the switch via a TFTP server. 

* Please read the documents in the zip file for further information.       


#######################################################################
FIXES/ENHANCEMENTS
#######################################################################

Version 1.0.0.24 is the maintainence release for the switch. 
Fixes the following field issues

- The configured asset tag value is seen via embedded web server (EWS), but is not displayed when doing show running configuration
- Service Tag is not displayed in CLI.
- Voice Vlan : Running and startup configuration mismatch
- Under the stacking configuration when the following command "show system id " is executed  only display slaves Service tag
- Under the stacking configuration WebUI allows to configure voice VLAN only on ports that reside on the master 
- 35xx link flopping with Cisco (3750) switches


#######################################################################
ADDITIONAL INFORMATION
#######################################################################

NOTE: The firmware may be upgraded using TFTP from the serial console 
interface, telnet or web user interface. 

When using a telnet session or web interface, the connection to the 
switch is not available until the switch has entered forwarding mode. 
This takes approximately three minutes from a power-up reset.  


#######################################################################
IMPORTANT INFORMATION
#######################################################################

**Please read the Adobe PDF documents enclosed in the ZIP download.**   


#######################################################################

Information in this document is subject to change without notice.
(C) 2008 Dell Inc. All rights reserved.

Reproduction in any manner whatsoever without the written permission 
of Dell Inc. is strictly forbidden.

Trademarks used in this text: "Dell", "Dell OpenManage",
"PowerConnect", and "PowerEdge" are trademarks of Dell Inc.;
"Windows Server" is a trademark, and "Microsoft", "Windows", and
"Wingdings" are registered trademarks of Microsoft Corporation
"Novell" and "NetWare" are registered trademarks of Novell Inc.;
"Red Hat" is a registered trademark of Red Hat, Inc.

Other trademarks and trade names may be used in this document to refer 
to either the entities claiming the marks and names or their products.  
Dell Inc. disclaims any proprietary interest in trademarks and trade 
names other than its own.

March 2008