#######################################################################

DELL POWERCONNECT 5224 v2.1.0.0 FIRMWARE README

#######################################################################

NOTE: This ReadMe provides information for PowerConnect 5224 v2.1.0.0 
firmware.


#######################################################################
CRITICALITY
#######################################################################

Recommended - Dell recommends applying this update during your next 
scheduled update cycle. The update contains feature enhancements or 
changes that will help keep your system software current and compatible 
with other system modules (firmware, BIOS, drivers and software). 


#######################################################################
DESCRIPTION
#######################################################################

* This is the firmware release v2.1.0.0 for the Dell PowerConnect 5224 
networking switch.

* This firmware is transferable to the switch via a TFTP server. 

* Please read the notes in the zip file for further enhancements and 
fixes.    


#######################################################################
FIXES/ENHANCEMENTS
#######################################################################

- Not properly dropping Cisco's PVST PDU's 

- Added PVST Filter

- Syslog shows invalid date and time

- MAC Address Table inconsistency

- With a fiber LAG hard set to 1000full will return to default LAG of 
Auto Negotiation

- Noval corrupt vlan ID 4294966296

- WBI Utilization chart values do not reflect utilization correctly

- Fiber ports do not work in forced mode

- ARP Corruption Issue - Loosing connectivity when uplink port 
configured as a Trunk and pinging from the DUT.

- Flash log message confusion

- Port 24,5224, cannot link at 100full, intermittent.

- Memory Leak when using HTTP & SSH, which eventually cause loss of 
Management   
 

#######################################################################
ADDITIONAL INFORMATION
#######################################################################

NOTE: Perform the upgrade procedure from the console interface via an 
RS232 serial port. When using a telnet session or web interface alone, 
your connection to the switch is not available until the switch has 
entered forwarding mode. This takes approximately three minutes.  


#######################################################################
IMPORTANT INFORMATION
#######################################################################

**Please read the Adobe PDF documents enclosed in the ZIP download.**   


#######################################################################

Information in this document is subject to change without notice.
(C) 2005 Dell Inc. All rights reserved.

Reproduction in any manner whatsoever without the written permission 
of Dell Inc. is strictly forbidden.

Trademarks used in this text: "Dell", "Dell OpenManage",
"PowerConnect", and "PowerEdge" are trademarks of Dell Inc.;
"Windows Server" is a trademark, and "Microsoft", "Windows", and
"Wingdings" are registered trademarks of Microsoft Corporation
"Novell" and "NetWare" are registered trademarks of Novell Inc.;
"Red Hat" is a registered trademark of Red Hat, Inc.

Other trademarks and trade names may be used in this document to refer 
to either the entities claiming the marks and names or their products.  
Dell Inc. disclaims any proprietary interest in trademarks and trade 
names other than its own.

May 2005